When a plotted line starts skipping, what do you check first?

A pen plot can look perfectly fine for several minutes, then suddenly start producing broken or inconsistent lines.

The difficult part is often figuring out whether the cause is the pen, ink flow, paper contact, plotting speed, or something else entirely.

What do you check first when a plotted line starts skipping?

A few useful questions:

  • Ink flow: Does the pen write consistently by hand, and does the problem appear only after plotting for a while?
  • Pen contact: Could pen height, tip angle, or uneven paper be causing intermittent contact?
  • Plotting speed: Does the same test line behave differently at a slower speed?
  • Consistency: Does skipping happen in the same direction, the same area of the paper, or with the same pen?

One approach is to change only one variable at a time. A short, repeatable test pattern can help distinguish between possible causes without wasting an entire drawing.

Of course, different pens and plotting machines may behave very differently, so there may not be a universal solution.

How do you troubleshoot this in your own setup?

Have you ever discovered that what looked like an ink-flow problem was actually caused by something else?

Share your troubleshooting routine, including your machine and pen type if relevant. Specific examples could make this a useful reference for other plotterfolk members.

I would troubleshoot it in this order:

  1. Make a short repeatable test—for example, parallel lines plus a few circles—so the symptom is easy to compare.
  2. Check the pen first: does it still write continuously by hand? Inspect the nib for dried ink or fibres, and gently clean or re-prime it if appropriate for that pen.
  3. Check contact: confirm that the nib is actually touching the paper throughout the test. A pen holder that allows rotation or a slightly uneven sheet can cause intermittent contact.
  4. Slow the plot down without changing anything else. If the skipping improves, speed, acceleration, or pen lift dynamics may be contributing.
  5. Compare patterns:
    • same location on the page → paper surface, height, or flatness
    • same direction → pen angle, holder movement, or drag
    • same pen only → pen, nib, or ink
    • all pens → machine setup, paper, or motion settings
  6. Try fresh paper and a second pen as control tests. Changing both at once makes the result difficult to interpret.

I would avoid immediately increasing force or lowering the pen, since that can worsen nib drag and damage the paper. Recording the machine, pen, ink, paper, speed, and the exact test pattern makes the eventual working configuration much easier to reproduce.

The paper comparison discussion may also be relevant: How much does paper change the behaviour of the same pen?