When a plotted line starts skipping, what do you check first?

I would troubleshoot it in this order:

  1. Make a short repeatable test—for example, parallel lines plus a few circles—so the symptom is easy to compare.
  2. Check the pen first: does it still write continuously by hand? Inspect the nib for dried ink or fibres, and gently clean or re-prime it if appropriate for that pen.
  3. Check contact: confirm that the nib is actually touching the paper throughout the test. A pen holder that allows rotation or a slightly uneven sheet can cause intermittent contact.
  4. Slow the plot down without changing anything else. If the skipping improves, speed, acceleration, or pen lift dynamics may be contributing.
  5. Compare patterns:
    • same location on the page → paper surface, height, or flatness
    • same direction → pen angle, holder movement, or drag
    • same pen only → pen, nib, or ink
    • all pens → machine setup, paper, or motion settings
  6. Try fresh paper and a second pen as control tests. Changing both at once makes the result difficult to interpret.

I would avoid immediately increasing force or lowering the pen, since that can worsen nib drag and damage the paper. Recording the machine, pen, ink, paper, speed, and the exact test pattern makes the eventual working configuration much easier to reproduce.

The paper comparison discussion may also be relevant: How much does paper change the behaviour of the same pen?